4 Replacement Procedures 4.34 TFT FL (Model 15.0 UXGA SHARP LQ150U1LW13)
4-166 Satellite Pro M10 Series Maintenance Manual (960-431)
14. Apply the protective cover-S, the aluminum tape and the wire-protective tape.
0
‘
0.5m m
0
‘
1mm
0
‘
1mm
0
‘
1mm
Protective cover-S
Aluminum sheet
Aluminum tape
Wire-protective tape
Align the holes on
the protective cover
with the pins on
the
P-chassis.
Align the edge of the tape
with the edge of the frame.
Secure the cable with wire-protective tape.
Be sure the cable lies flat.
Apply the aluminum tape around
the center of the module.
Apply the protective cover-S along the top frame
and fold the cover to the side.
Figure 4-147 Applying the protective cover-S and taps
To Next Page
Loading...
