OPERATOR’S MANUAL
series Robot Controller
1.4.4 Assigning a Name to Load Data
When entering load data, you have to assign a load name to that data. A load in
the program is specified by the load name.
Generally, the load name has the following format.
SAMPLE1
Load name (1 ~ 10 characters)
The following characters can be used for the load name. The first letter of a load
name must be an alphabetical character.
Alphabetic characters : A ~ Z
Numerals : 0 ~ 9
Cautions: You cannot use an identifier (reserved word) used for the SCOL
language to name a point. For details, see Appendix B of the Robot
Language Manual.
The load name entered should consist of up ten (10) characters. If it
exceeds this limit, the entry is invalid with an error saying "illegal name"
displayed.
If a character other than the alphabetical characters has been entered
for the first character of the load name, the entry is invalid with an error
saying "illegal name" displayed.
STE 80720
– 1-18 –
To Next Page
Loading...
Need help?
General
