OPERATOR’S MANUAL
series Robot Controller
(c) Step 3: Input of replacement character string.
Make sure that "Replacement:" is displayed on the last line of the display,
enter a replacement character string and press the EXE key.
P R G R A M . N A M C : 5 L : 1
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
R e p l a c e m e n t : M O V E S _
S A V E D E D I T J U M P F I N D C H A N G >
Unless the specified character string exists, a message of "Not found." is
displayed and the character string replacement terminates.
P R G R A M . N A M C : 5 L : 1
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
N o t f o u n d .
S A V E D E D I T J U M P F I N D C H A N G >
(d) Step 4: Confirmation of replacement.
The cursor moves to the top of the character string initially found with the
following message displayed.
P R G R A M . N A M C : 1 L : 3
P R O G R A M T E S T
S P E E D = 5 0
M O V E A
M O V E B
M O V E C
0 : l o c a l , 1 : g l o b a l , E S C : e x i t
S A V E D E D I T J U M P F I N D C H A N G >
STE 80720
– 4-29 –
To Next Page
Loading...
Need help?
General
