Figure 7-6 Port Config
The following entries are displayed on this screen:
Port Config
Port Select: Click the Select button to quick-select the corresponding port
based on the port number you entered.
Select: Select the desired port for STP configuration. It is multi-optional.
Port: Displays the port number of the switch.
Status: Select Enable /Disable STP function for the desired port.
Priority: Enter a value from 0 to 240 divisible by 16. Port priority is an
important criterion on determining if the port connected to this
port will be chosen as the root port. The lower value has the
higher priority.
ExtPath: ExtPath Cost is used to choose the path and calculate the path
costs of ports in different MST regions. It is an important criterion
on determining the root port. The lower value has the higher
priority.
IntPath: IntPath Cost is used to choose the path and calculate the path
costs of ports in an MST region. It is an important criterion on
determining the root port. The lower value has the higher priority.
Edge Port: Select Enable/Disable Edge Port. The edge port can transit its
state from blocking to forwarding rapidly without waiting for
forward delay.
P2P Link: Select the P2P link status. If the two ports in the P2P link are root
port or designated port, they can transit their states to forwarding
rapidly to reduce the unnecessary forward delay.
MCheck: Select Enable to perform MCheck operation on the port.
Unchange means no MCheck operation.
STP Version: Displays the STP version of the port.
86
To Next Page
Loading...
Need help?
General
Weight and Dimensions
