97
f single-phase power with R/L1,S/L2 terminals.
c. Parameter setting:
F4.08 (Motor Rated Current)=
F3.04 (Stall Prevention Level at the Constant Speed)=80
b. Connect the wires o
Please reset above parameters. If the parameters are not modified,
the motor and drive could be possibly damaged.
3.1A
(the setting must be based on the motor rated current)
F4.28 (Overload Detection Level)=80
(the half of the default setting value 160%)
(the half of the default setting value 160%)
To Next Page
Loading...