TPG CA-202A - F5 Multi-function Parameters

F5 Multi-function Parameters
Func. Name
Descriptions
Range of
Setting
Unit
Factory
Setting
Note
F5.00
“Pot knob”
Selection
(Analog
Input)
0: Analog input gain
1: Frequency command
2: Current limit
3: Variable voltage of V/F pattern
0~3 ─ 1
*Note 9
F5.01
AI Selection
(Analog
Input)
0: Analog input gain
1: Frequency command
2: Current limit
3: Variable voltage of V/F pattern
4: PTC temperature
5: PID feedback
0~5 ─ 1
*Note 9
F5.02 Reserved Reserved
*Note 9
F5.03
Pot Gain
(Analog
Input)
A
nalog input of “Pot knob” gain 0.00~2.00 0.01 1.00
*Note 9
F5.04
“Pot knob”
Bias
(Analog
Input)
A
nalog input of “Pot knob” bias -1.00~1.00 0.01 0.00
*Note 9
F5.05
AI Gain
(Analog
Input)
A
nalog input of AI gain 0.00~2.00 0.01 1.00
*Note 9
F5.06
AI Bias
(Analog
Input)
A
nalog input of AI bias -1.00~1.00 0.01 0.00
*Note 9
F5.07
Filter Setting
of Analog
Frequency
Filter the signal based on analog input
setting.
0~255 ─ 20
*Note 9
F5.08
Analog
Frequency
Dead Band
When signal noise is large,
appropriately increase the dead band
to stabilize the frequency. But this will
reduce the tuning linearity.
0.00~2.55 0.01Hz 0.00
*Note 9
F5.09
Acceleration
Time of V
Set the acceleration time of the variable
voltage of V/F pattern.
0.0~3200.0 0.1sec 5.0
*Note 9
F5.10
Deceleration
Time of V
Set the deceleration time of the variable
voltage of V/F pattern.
0.0~3200.0 0.1sec 5.0
*Note 9
The color as means functions can be set during the operation.
33