• Scratch Sensitivity: by default set to 50%; adjust the Scratch sensitivity and check in real
time if the change accommodates you better.
• Bend Invert: by default deactivated; swiping to the left slows playback down momentarily.
If activated, swiping to the left nudges playback forward.
• Scratch Invert: by default activated; swiping to the left advances playback position in the
track. If deactivated, swiping to the left goes back in a track.
• Shift + Touch to Scratch: by default deactivated, holding the SHIFT button +swiping
within the Touch Strip performs an absolute seek. If activated, holding the SHIFT button
+swiping within the Touch Strip performs a scratch effect or backspin.
5.4 Calibrate
Calibration ensures that each control allows adjustments over their full range and with maxi-
mum precision. These settings are precisely calibrated during production, although they might
need to be recalibrated over the lifetime of your D2 unit. Recalibration is necessary when a
control ceases to allow you to set actual minimum and maximum values.
Calibration is done in groups of control elements, just click the corresponding Recalibrate but-
ton:
• FX Knobs: for recalibrating the FX knobs on both FX Units 1 and 2.
• Short Faders: for recalibrating the Slot Volume Faders.
5.5 LEDs
The pad and button backlights on the D2 offer two distinct brightness levels to indicate On
and Off states. Depending on your light conditions during a performance, it can be necessary
to adjust these.
On State Brightness: sets the brightness level for engaged buttons and pads.
Dim State Percentage: sets the brightness level for inactive buttons and pads.
Preferences Pane in TRAKTOR
Calibrate
TRAKTOR KONTROL D2 - Manual - 154
To Next Page
