Traktor KONTROL D2 - Setting up an FX Unit in Single FX Mode

→
You have exchanged effects slot 2 in the Group FX. Repeat this process for any of the
remaining effects in the Group FX.
3.8.4 Setting up an FX Unit in Single FX Mode
While a Group FX setup gives you control over up to three effects with one parameter each,
setting an FX unit to Single mode provides access to three parameters of a single effect.
We will set up FX Unit 2 in Single FX mode and load a Delay effect:
Prerequisites
• The D2 controls the right Decks B and D so that the FX Unit of the D2 controls FX Unit 2
of the TRAKTOR software.
• The track "Techno 2" is loaded into Deck B. The track is playing and audible.
To load a Single FX to FX Unit 2:
Using Your D2—Getting Advanced
Adding FX
TRAKTOR KONTROL D2 - Manual - 96