transnorm TS 1208 - Page 22

Safety
Remaining risks regarding the machine
22
Operating instructions: Belt conveyor TS 1208
Version 1.6ENG, 10/04/2018
Measures for technical personnel to avert risk and prevent damage
Danger Cause Measure
Risk of fatal
injury
Accidental machine
restart
During maintenance/repair work:
 Inform your colleagues that it is prohibited to
re-start the machine until notified otherwise
 Disconnect the power supply
 Apply a label to prevent accidental re-
connection of the power supply
 Prevent accidental re-connection of the
power supply as described in the operating
instructions of the system
Electricity Machine shut-down:
 Disrupt power supply
 Secure system against accidental re-start
 Establish that the power is off
Falling or slipping
loads
Transport and installation:
 Observe the centre of gravity of the
machine and the permissible lifting load of
the hoists
 Secure the machine and hoists to prevent
slipping
 Read the section on "Transport and installa-
tion" and carefully observe the instructions
For ceiling suspension of conveying systems:
 Observe the assembly instructions of the
suspensions used
Fire hazard Non-permitted oper-
ating conditions,
e.g., accumulation of
load residue, pack-
aging abrasion, dust
During maintenance/repair work:
 Observe maintenance intervals