transnorm TS 1208 - Page 23

Safety
Remaining risks regarding the machine
23
Risk of
injury
Sharp-edged
machine parts
During maintenance/repair work:
 Be alert and proceed with caution
 Avoid hectic movements
 Wear appropriate protective clothing
Rotating parts For maintenance and adjusting works:
 Do not reach into rotating parts
 Wear close-fitting protective clothing
 Have one or more other persons assist you
 Observe warning labels on the machine
Falling machine
parts
During maintenance/repair work:
 Support heavy parts (especially motors)
 Do not step under loose parts or touch them
 Secure working area so that personnel are
not at risk
When working at suspended machines:
 Cordon off the work area
 Have a second person supervise the opera-
tion
 Put tools and parts down carefully and
prevent them from falling
Hot
electric motors
Before touching:
 Allow enough time for them to cool down
 Wear suitable and thick protective clothing
Accumulation of
conveyed material
Before remedying a fault:
 Carefully observe conveyor system
 Assess whether the system needs to be
stopped due to an unclear situation
While remedying a fault:
 Keep body parts away from the conveyed
loads
 Remove any pile-up of conveyed material
 Only switch the system on again when pile-
up of conveyed material has been removed
Conveyed loads During operation:
 Do not reach into conveyed loads
 Observe warning labels on the machine
While remedying a fault:
 Assess whether the system needs to be
stopped due to an unclear situation
 If necessary, secure the system so that it
cannot restart inadvertently
 Be alert and proceed with caution
During maintenance/repair work:
 Disconnect the machine from electric supply
during works
 Secure the system against accidental re-
start
Measures for technical personnel to avert risk and prevent damage
Danger Cause Measure