58 Juno Series Handhelds User Guide
– a serial device, such as a GeoBeacon receiver or a laser rangefinder, select
Serial Port.
– a computer to access ActiveSync technology (or WMDC), select
ActiveSync.
Note – On
ly ActiveSync shows on the Windows embedded handheld. Select ActiveSync
even if you use the WMDC on the desktop computer.
Note – F
or more information on the types of devices that the Juno series handheld can
connect to, and the supported Bluetooth services, see Connecting to a Bluetooth device as a
client, page 55.
11. Tap
Save.
12. Tap
OK to close the Bluetooth application.
13. Tap to close the S
ettings screen.
You have now created a partnership between the Juno series handheld and the other
Bl
uetooth-enabled device so that they can communicate. To start using the
connection, you must complete the configuration steps for that type of connection and
then connect to the device. For more information, see:
• Connecting to a Bluetooth-enabled phone for Internet access, page 60
• Connecting to a Bluetooth-enabled serial device, page 65
• Connecting to an office computer using Bluetooth wireless technology, page 66
B
Tip – You only need to pair the handheld with a device before you connect to the device
for the first time.
Setting up a connection to a non-paired device
Setting up a connection to a non-paired device enables you to connect to a device that
does not allow you to enter a passcode on the device, or that does not automatically
exchange a pre-programmed passkey during pairing.
To set up a non-paired connection to a
Bluetooth-enabled device:
1. Make sure that the handheld and the Bluetooth device you want to connect to
ar
e within five meters of each other, and that the Bluetooth radio in each device
is turned on.
2. Tap
/ Settings / Bluetooth.
To Next Page
Loading...