31
10. Logging In to the KVM over IP
10.3 AP Java Client Login
In cases when an Administrator does not want the KVM Switch to be available via browser and the remote user is not running Windows, the AP
Java Client provides access to the KVM switch.
After downloading the AP Java Client, double-click on the program download location on your hard disk to show the connection screen. The AP
Java Client connection screen is the same as the Windows version, except it does not contain a menu bar with File and Help menus.
Note: When accessing the AP Java Client for the first time, a prompt will appear requesting a software serial number. This serial number can be found on the
included CD.
1. If your KVM is displayed in the Server List, connect by highlighting the desired KVM and clicking the Connect button.
Note: For a switch to appear in the Server List, the Enable Client AP Device List check box in the Operating Mode page of the Web Interface’s Device
Management section must be checked and the Program service port in the Network page must be set to the same number as in the AP Windows Client Port
field.
2. If your KVM does not display in the Server List, enter its IP address in the IP server field and click the Connect button.
3. A prompt will appear requesting a username and password. Enter your username and password, then click OK.
4. Once connected, the Remote View button will be activated. Click on it to access the KVM remotely. Click the Disconnect button to log out
of the KVM switch.
To Next Page
Loading...
Need help?
General
