A Lightweight partition wall with metal support
structure or steel support structure / compart-
ment wall / safety partition wall
B Lightweight partition wall with metal support
structure or steel support structure / compart-
ment wall / safety partition wall, installation near
the floor
C Lightweight partition wall with metal support
structure or steel support structure / compart-
ment wall / safety partition wall, installation near
the ceiling
4.1 Solid ceiling slab / solid floor
5.1 Dry wall screw
5.6 Screw or steel rivet
6.5 Mineral wool (depending on wall construction)
7.1 UW section
7.1a UW section, cut in and bent or cut off
7.1b UW section, only for mortar-based installation,
nominal sizes Æ nominal width 450 - 800
7.2 CW section
7.3 UA section
7.10 Trim panels according to installation details
7.13 Cladding
7.23 Sheet steel layer depending on wall manufac-
turer (if any)
☐A Installation opening
☐A1 Opening in the metal support structure
(without trim panels: ☐A =☐A1)
* Closed side of metal section must face the
installation opening
Installation
Lightweight partition walls > General
Fire damper FKR-EU 51
To Next Page
Loading...
