Appendix F–2
WINDOWS 95/98 HYPERTERMINAL
To print (upload) data from the 4640-B gauge to a computer
equipped with the Windows 95 or 98 operating system, use the
HyperTerminal program as described in the following sections.
HYPERTERMINAL SETUP
To configure the Windows 95/98 HyperTerminal program and set
up a dedicated icon to transfer data from the 4640-B gauge, perform
the following steps:
1. Click on the Start button, then select the P
rograms menu and
the Accessories folder.
In Windows 95, select the HyperTerminal icon.
In Windows 98, select the Communications subfolder,
then select the HyperTerminal icon.
2. From the HyperTerminal window, double-click on the
Hypertrm icon. The Connection Description window is
displayed. This window is used to set up a new connection.
3. In the N
ame box, enter a name (for example, Troxler Data) for
the new connection. Select an icon to use for the connection,
then click OK. The Connect To window is displayed.
4. In the Connect To window, do not enter a telephone number.
Instead, select Direct to Com1, Direct to Com2, Direct to
Com3, or Direct to Com4, depending upon the computer.
The COM# Properties window is displayed, where # is the
number of the selected COM port.
5. Configure the Port Settings as follows:
B
its per second 2400
D
ata bits 8
P
arity None
S
top bits 1
F
low control Hardware
To Next Page
Loading...
