Troxler 4640-B - Equipment Connection; Printing (Uploading) Project Data

Model 4640-B Appendix F–3
F. DOWNLOADING DATA
6. Click OK. The Troxler Data – HyperTerminal window is
displayed, where Troxler Data is the icon name entered in
step 3.
7. From the toolbar, click on F
ile and select Save from the
dropdown menu.
8. Close the Troxler Data – HyperTerminal window by
selecting Ex
it from the File menu.
EQUIPMENT CONNECTION
Connect the gauge to the computer using the appropriate serial cable
(see the list of Accessories on page C–14). Connect the gauge’s
serial port (see Figure 4–1 on page 4–4) to the computer COM port
selected in step 4 of the HyperTerminal Setup section on the
previous page.
PRINTING (UPLOADING) PROJECT DATA
To print (upload) project data from the gauge to the computer:
1. On the computer, click on the Start button, then select the
P
rograms menu and the Accessories folder.

In Windows 95, select the HyperTerminal icon.

In Windows 98, select the Communications subfolder,
then select the HyperTerminal icon.
2. From the HyperTerminal window, double-click on the
Troxler Data – HyperTerminal icon (where Troxler Data is
the icon name entered in the HyperTerminal Setup section on
the previous page). The Troxler Data – HyperTerminal
window is displayed.
3. From the toolbar, click on T
ransfer, then select Capture Text
from the dropdown menu. The Capture Text window is
displayed, showing the default folder and filename to be used to
store the data. Troxler recommends using the default settings
when first using the program.