STORING A MEASUREMENT
After reviewing the data, the reading may be stored under the active
project number, allowing the data to be recalled and printed at a
later time.
When the measurement has been completed press 〈STORE〉. The
display will request a station number.
Station Number?
------
Input and
Press ENTER
Input a station number or reading number (up to six characters) and
press 〈START/ENTER〉.
Distance from
center line ?
-----.--
(Press ENTER)
Input the distance from the centerline (if applicable) and press
〈START/ENTER〉. The gauge will request if the measurement was
to the left (press 〈1〉) or right (press 〈2〉) of the centerline.
Additional information such as grid coordinates, mix type, or any
other numeric information may be stored (up to twelve characters
per line). To store additional information, press 〈YES〉. To exit,
press 〈NO/CE〉.
4. PROJECT DATA
Model 4640-B 4–3
To Next Page
Loading...
