WINDOWS 3.1 TERMINAL
To print (upload) data from the 4640-B gauge to a computer
equipped with the Windows 3.1 operating system, use the Terminal
program as described in the following sections.
TERMINAL SETUP
To configure the Windows 3.1 Terminal program to transfer data
from the 4640-B gauge, perform the following steps:
1. From the Windows Program Manager, select Accessories
then click on the Terminal icon. The Terminal window is
displayed.
2. From the toolbar, select S
ettings, then select
C
ommunications from the dropdown menu.
3. Configure the communications settings as follows:
B
aud Rate 2400
Data Bits 8
S
top Bits 1
P
arity None
F
low control Hardware
C
onnector Select COM1, COM2, COM3,
or COM4, depending on the
computer
4. Click OK to return to the Terminal window.
F. DOWNLOADING DATA
EQUIPMENT CONNECTION
Connect the gauge to the computer using the appropriate serial cable
(see the list of Accessories on page C–14). Connect the gauge’s
serial port (see Figure 4–1 on page 4–4) to the computer COM port
selected in step 3 of the Terminal Setup section above.
Model 4640-B Appendix F–5
To Next Page
Loading...
