TSC TDP-247 Service Manual

48
5. GAP AND BLACK MARK SENSOR SELECTION
Both gap sensor and black mark sensor are available in TDP-245 Plus series.
Gap sensor is set as default, so there is no extra setting for gap sensor.
Gap Sensor
 Default setting. No extra action necessary.
 If you would like to switch back to gap sensor, please initialize the printer.
Black Mark Sensor
 Go to MS-DOS prompt mode and enter following command to switch sensor to
black mark sensor.
 C:\>COPY CON LPT1 <ENTER>
BLINE width, offset <CTRL><Z> ex: BLINE 3 mm, 0
C:\>
Or start the labeling software, set sensor to black mark sensor then print one label.
The sensor will be switched to black mark sensor.
Please calibrate the sensor after sensor selection.
Note:
1. <ENTER> means PC keyboard “Enter” key.
2. <CTRL><Z> means to hold “CTRL” key then press “Z” key.

TSC TDP-247 Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Communication Interface	USB 2.0, RS-232
Power Supply	100-240V AC, 50/60 Hz
Operating Temperature	41°F - 104°F (5°C - 40°C)
Operating Humidity	85% non-condensing
Max. Print Width	4.09" (104 mm)
Label Width	1.18" - 4.33" (30 mm - 110 mm)
Storage Temperature	-40 ~ 60°C (-40 ~ 140°F)