turbofan 30D Series - Controller - Operator Settings; Changing Operator Settings; Operator Settings Reference

18
5 Parts Replacement
Amendment 10
11 May 2015
5.1.9 Door Inner Glass / Door / Door Hinges
To replace Door Inner Glass:
1. Undo inner glass retaining clip.
2. Lift inner glass up and pull bottom outwards to free bottom
pivot.
NOTE: Pivot spacer is a loose fit over pivot and may fall
out.
3. Lower inner glass to free top pivot and remove glass.
4. Replace and refit door inner glas
s in reverse order, remember
to ref
it Pivot Spacer to bottom hing
e.
To replace Door:
1. Remove door inner glass (as above).
2. Whilst supporting door, unscrew and remove top door hi
nge
pi
vot bolt from the door top hinge assembly
.
3.
Remove the Nord-Lock Washer.
4.
Lift door off the bottom hinge.
5.
Refit door in reve
rse order.
Remove Door Top Pivot Bolt.
Pivot Spacer
Retaining Clip
To replace Door Hinges:
1. Remove door and inner glass complete. (as shown previous
).
2.
Remove 2 Hinge Plate Screws
.
3.
Remove the upper and lower hinge plates
.
4.
Refit replacement door hinge plates.
5. Refit door and inner glas
s.
NOTE
: The Door Hinge Assembly can be ordered as a
complete Door Hinge Replacement Kit or as
separate items as shown below.
To replace Door Hinge Pivot Bushes:
1.
Remove door complete
.
2.
Unscrew and remove top and bottom plates from the door
.
3.
Tap out the old Door Hinge Pivot Bushes and discard.
4. Gently Tap in the new pivot bushes
.
5
. Refit the oven door as shown opposite.
Remove Top or Bottom
Hinge Plate Screws.
Door Hinge Pivot Bush.
Nord-Lock Washer.
Door Hinge Pivot Pin.
Door Bottom Hinge Assemby.
Door Top Hinge Assemby.
Door Hinge Pivot Bush.
Nord-Lock Washer.
Door Hinge Pivot Pin.
Nord-Lock Washer.
Pivot Bush
Unscrew 2 Screws
Door Hinge Pivot Bush.