EasyManuals Logo

turbofan 30D Series Service Manual

turbofan 30D Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Service Procedures
11
5.1 Access
5.1.1 Control Panel
1. Remove screw on
underside of control
panel.
2. Lift control panel up
to unhook top of
panel from proofer /
holding cabinet.
5.1.2 LH / RH
Side Access Panels
1. Remove 2 screws on
lower corners of side
panel.
2. Pull bottom of panel
out and away from
bottom of proofer /
holding cabinet.
3. Pull down on panel to
remove.
5.1.3 LH / RH Proofer / Holding Cabinet
Side Racks
Side Racks - P10
a. Lift up and remove side rack out of proofer /
holding cabinet.
Side Racks - P8 / P12
a. Take hold of top and bottom of rack and lift front of
rack upwards to disengage front upper and lower
hangar studs.
b. Swing rack inwards.
c. Take hold of top and bottom rack at centre and lift
rear of rack upwards to disengage rear upper and
lower hangar studs. Lift rack out of proofer /
holding cabinet.
5.1.4 Fan Baffle
1. Remove RH proofer / holding cabinet RH side rack as
shown above.
2. Lift Fan Baffle up to unhook from side of proofer /
holding cabinet and remove.
Securing Screw
Securing Screws
5.2 Replacement
5.2.1 Function Control Switch
1. Remove knob from
switch spindle. Knob is
a push fit.
2. Remove control panel
(Refer Section 5.1.1).
3. Remove 2 switch
mounting screws and
remove switch from
control panel.
4. Remove wires from rear
of function control
switch, noting their
position.
5. Re-assemble in reverse
order.
5.2.2 Thermostat Control Switch
1. Remove knob from
switch spindle. Knob is
a push fit.
2.
Remove control panel
(refer Section 5.1.1).
3. Remove 2 switch
mounting screws and
remove switch from
rear of control panel.
4. Disconnect wires from
rear of Control Switch,
noting their position.
5. Remove RH Rack from
proofer / holding
cabinet. (refer Section
5.1.3).
6. Remove Fan Baffle.
(refer Section 5.1.4).
7. Remove RH access
panel (refer Section
5.1.2).
8. Remove phial from
holder inside Proofer.
9. Withdraw phial through
the proofer / holding
cabinet sidewall.
10. Re-assemble in reverse
order.
Securing Screws
Securing
Screws
Thermostat
Phial

Table of Contents

Other manuals for turbofan 30D Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the turbofan 30D Series and is the answer not in the manual?

turbofan 30D Series Specifications

General IconGeneral
Brandturbofan
Model30D Series
CategoryCommercial Food Equipment
LanguageEnglish