6
2 Installation
Amendment 10
11 May 2015
Water Connection - Optional
NOTE: If the Moisture Mode cooking option is not required,
the oven does not need to be connected to a water
supply.
1. Tighten 2 screws securing water
con
nection to rear of oven. (The
se
have p
urposely been left loos
e to
prev
ent damage to the wate
r
con
nection during transit).
2. Connect a cold water supply to th
e
w
ater inlet (R ¾” Connector) on th
e
oven.
- Max Inlet Pressure 80psi / 550kPa.
3.
Turn ‘On’ the water supply and check for leak
s.
Recommended Water Specifications
In order to prevent corrosion or scaling in the oven and water
system due to supplying water that is either too soft or too hard,
the following recommendations should be used as a guideline.
Hardness: Between 60 and 90ppm.
PH: Greater than 7.5.
Chlorides: Less than 30 ppm.
Positioning and Levelling of Oven
1. Correctly locate the oven into its final operating position and
using a spirit level, adjust the oven feet so that the oven is
level and at the correct height.
Stand Mounted Ovens
For ovens that are to be mounted to a stand, the oven legs are
used to level the oven on the stand. Refer to the
instructions supplied with separately ordered stands for mounting
details.
Initial Start-Up
Before using the new oven;
1. For first time use of the oven, operate the oven for about 1
hour at 200°C/ 400°F to remove any fumes or odours whic
h
may
be present.
2.
Please refer to the Operation Section of this manual for detail
s
on how t
o correctly operate and shutdown the ov
en.
Commissioning
Before leaving the new installation;
Check the oven functions in accordance with the operating
instructions specified in the ‘Operation’ section of this manual.
Lighting the oven.
Turning ‘Off’ the oven.
Ensure that the operator has been instructed in the areas of
correct lighting, operation, and shutdown procedure for the
appliance.
NOTE: If for some reason it is not possible to get the
appliance to operate correctly, shut off the gas
supply and contact the supplier of this appliance.
Tighten Screws.
To Next Page
Loading...
Need help?
General
