25
Controller Programming 6
Amendment 10
11 May 2015
Parameter
Number
Description Min Max
Default
U of M
Pass
0
G32R01 G32R03
P16
Oven Fan Rotation Time.
The time the fan will rotate in one
direction before changing direction.
1 999 120 120 sec S
P17
Oven Fan Reversing Pause Time.
The time between the fan
stopping and re-starting in the opposite direction.
5 10 10 10 sec S
voL
Buzzer Volume.
Volume of buzzer can be adjusted between ‘
O’ - No Buzzer and ‘10’ - Maximum Volume.
0 10 5 5 --- U
P20
Thermal switch NO or NC contacts
0 1 1
1
--- S
PrE
Program Preheating Offset.
In Program Mode only. The
temperature above ‘Set Temperature’ that the oven will pre-heat
to. (To allow for heat loss during door opening and cold product
loading
). Note;- Upon starting the Program, Oven Set
Temperature will revert to the Set Temperature.
0 (0) 30 (54) 20 (36) 0 ˚C (˚F) U
P22
Maximum Door Open Time - Program Mode Only.
This is the time allowance for door open when loading oven, to
avoid Pre-Heating state re-activating once the door is closed.
Note: If door has been open longer than the time set (60)
and actual temperature has dropped below the set
temperature for that program, when the door is closed, the
oven will revert to the Pre-heating Mode.
30 180
60 60
sec S
P25
Core Probe Temperature Offset.
This offset is always added to
the raw temperature measurement, to correct displayed value.
(Value shown on display is the corrected value).
25 (-45) 25 (45) N/A 0 ˚C (˚F) S
StG
Enable Multi-Stage Cooking.
This new parameter will control
whether or not the oven can program with multiple stages. Setting
defaults to ‘No’ ensuring programming for single stage ios as in
previous revision (No decimal numbers e.g. 1.1, 1.2 to indicate
stages).
no YES N/A YES ---- U
P26
Maximum number of stages.
2 5 N/A 3 —- S
(0) Defines the password level of the parameter (S = Service / Factory Password level 321)
(U =
User Password level 123)
.
Viewing / Changing Service Parameters (from Ser. No. 762120) (Cont.d)
To Next Page
Loading...
