56
Battery Hatch Removal
• Locate the Battery Compartment on the back of the Module.
• While applying steady inward pressure on the center of the
Battery Hatch, rotate the Hatch Retaining Ring 10 degrees
clockwise using a flat blade screwdriver (Fig. 62) or a
Battery Hatch Tool.
• Lift the Hatch Ring up and away from the Housing, or turn
the Module over to allow it to drop out into your hand.
• Remove the Battery Hatch.
Battery Removal
• Remove the Retaining Bar located across the lower portion of
the Battery (Fig. 63a).
• Remove the Hatch O-ring. DO NOT use tools
• Using care not to damage the Battery Contacts (Fig. 63b/c),
slide the Battery up and out of the Battery Compartment.
Inspection
• Closely check all of the sealing surfaces for any signs of
damage that might impair proper sealing.
• Inspect the Button, Lens, and Housing to ensure they are not
cracked or damaged.
• If it is necessary to clean the Battery Compartment, flush it
and all components with a solution of 50% white vinegar
and 50% fresh water. Rinse with fresh water, and allow to
dry overnight, or blow dry with a hair dryer (set at 'no heat').
Fig. 62 - RING REMOVAL
Fig. 63 - HATCH REMOVAL
a
b
c
To Next Page
Loading...
