UD Trucks UD2000 - Default Chapter; Table of Contents

CONTENTS
IMPORTANT NOTICE......................................................................1
A : GENERAL INFORMATION
INCOMPLETE VEHICLES-SUBSEQUENT MANUFACTURERS
AND CERTIFICATION................................................................ A1
TERMS (AS DEFINED BY THE U.S. NATIONAL TRAFFIC
AND MOTOR VEHICLE SAFETY ACT AND REGULATIONS)... A2
FEDERAL MOTOR VEHICLE SAFETY STANDARDS
AND REGULATIONS APPLICABLE TO TRUCKS
WITH A GVMR GREATER THAN 10,000 POUNDS)................... A3
NOISE EMISSION CONTROL SYSTEMS AND MODIFICATIONS ... A3
EMISSION CONTROL SYSTEMS AND MODIFICATIONS ............... A4
LABEL AND IDENTIFICATION PLATE ........................................A5∼A6
B : CHASSIS-CAB DATA
CHASSIS-CAB DATA CHART............................................................ B1
CONVERSION FACTORS.................................................................. B1
CHASSIS-CAB DIMENSIONS AND MASSES ................................... B2
CHASSIS DIAGRAM FRONT AND REAR VIEW ............................... B3
CHASSIS DIAGRAM PLAN AND SIDE VIEW..............................B4∼B6
REAR-OF-CAB DATA......................................................................... B7
AXLE AND WHEEL DATA............................................................B8∼B9
CAB DATA........................................................................................ B10
FRAME DATA........................................................................... B11∼B13
CROSSMEMBER AND FRAME SECTION DATA....................B14∼B15
SIDE RAIL DATA......................................................................B16∼B19
BATTERY BOX DATA ...................................................................... B20
EXHAUST PIPE AND MUFFLER DATA...................................B21∼B23
FUEL TANK DATA ............................................................................B24
TRANSMISSION P.T.O. OPENING DATA............................... B25∼B26
SPRING DATA ................................................................................. B27
PROPELLER SHAFT DATA.....................................................B28∼B30
AREA USED FOR U-BOLTS WHICH CONNECT
EQUIPMENT AND FRAME ................................................ B31∼B33
C : BODY INSTALLATION INFORMATION
INFORMATION CHART..................................................................... C1
ENGINE EXTERNAL VIEW..........................................................C2∼C4
BRAKE SYSTEM DIAGRAM.............................................................. C5
FRAME HEIGHT CALCULATION ...................................................... C6
FRAME AND BODY INSTALLATION.........................................C7∼C16
ELECTRIC WIRING INFORMATION .......................................C17∼C22
ENGINE CONTROL .................................................................C23∼C26
REMODELING THE EXHAUST EMISSION SYSTEM..................... C27
WIRING DIAGRAM INFORMATION ........................................C28∼C51