CONTENTS
IMPORTANT NOTICE......................................................................1
A : GENERAL INFORMATION
INCOMPLETE VEHICLES-SUBSEQUENT MANUFACTURERS
AND CERTIFICATION................................................................ A1
TERMS (AS DEFINED BY THE U.S. NATIONAL TRAFFIC
AND MOTOR VEHICLE SAFETY ACT AND REGULATIONS)... A2
FEDERAL MOTOR VEHICLE SAFETY STANDARDS
AND REGULATIONS APPLICABLE TO TRUCKS
WITH A GVMR GREATER THAN 10,000 POUNDS.................... A3
NOISE EMISSION CONTROL SYSTEMS AND MODIFICATIONS ... A3
EMISSION CONTROL SYSTEMS AND MODIFICATIONS ............... A4
LABEL AND IDENTIFICATION PLATE ........................................A5∼A6
B : CHASSIS-CAB DATA
CHASSIS-CAB DATA CHART............................................................ B1
CONVERSION FACTORS.................................................................. B1
CHASSIS-CAB DIMENSIONS AND MASSES ................................... B2
CHASSIS DIAGRAM FRONT AND REAR VIEW ............................... B3
CHASSIS DIAGRAM PLAN AND SIDE VIEW..............................B4∼B8
REAR-OF-CAB DATA......................................................................... B9
AXLE AND WHEEL DATA................................................................ B10
CAB DATA.........................................................................................B11
FRAME DATA................................................................................... B12
CROSSMEMBER AND FRAME SECTION DATA............................ B13
SIDE RAIL DATA.............................................................................. B14
BATTERY BOX DATA ...................................................................... B15
BRAKE POWER UNIT AND AIR RESERVOIR DATA ..................... B16
EXHAUST PIPE AND MUFFLER DATA........................................... B17
FUEL TANK DATA............................................................................ B18
TRANSMISSION P.T.O. OPENING DATA...............................B19∼B22
SPRING DATA................................................................................. B23
PROPELLER SHAFT DATA.....................................................B24∼B26
RECOMMENDED POSITION USED FOR NO. 1 U-BOLTS WHICH
CONNECT EQUIPMENT AND FRAME ......................................B27
C : BODY INSTALLATION INFORMATION
INFORMATION CHART..................................................................... C1
ENGINE EXTERNAL VIEW..........................................................C2∼C4
BRAKE SYSTEM DIAGRAM.............................................................. C5
FRAME HEIGHT CALCULATION ...................................................... C6
FRAME AND BODY INSTALLATION.........................................C7∼C16
ELECTRIC WIRING INFORMATION .......................................C17∼C21
ENGINE CONTROL .................................................................C22∼C25
REMODELING THE EXHAUST EMISSION SYSTEM..................... C26
PROCEDURE FOR RELOCATING THE
OUTSIDE MIRRORS..........................................................C27∼C29
WIRING DIAGRAM INFORMATION ........................................C29∼C53
To Next Page