Ulma ENKOFORM VMK - Criterion to be Followed

ENKOFORM VMK
Construcción
29


ENKOFORM VMK
Joint of 2 MK-120 WALERS by means of the ADJUSTABLE
CONNECTOR MK.
4.1.4 Criterion to be followed
 Whenever PANELS are assembled by means of
WALER CONNECTORS MK or ADJUSTABLE
CONNECTORS MK, the BOARD must be placed
before shifting the PANEL.
 Whenever it is possible, MK-120 WALERS
will be assembled in zigzag, always trying
to be different in length, i.e.: it is better a
WALER MK-120 of 3.125+2.125 than
another of 2.625+2.625. This way, the joint
will never be in the same point.

Position of WALER CONNECTOR or ADJUSTABLE CONNECTOR in
a PANEL.