Ulma ENKOFORM VMK - Board Placement in Panels

ENKOFORM VMK
Construcción
30


ENKOFORM VMK
4.2. BOARD PLACEMENT IN PANELS
The width of the PANEL is delimited by the width of the BOARD. When a PANEL is 5 m wide, that means that its
BOARD is 5 m wide.
Nevertheless, as seen in chapter 4.1, the length of the WALER MK-120 is 125 mm shorter than the width of the
PANEL.
Example:
a 5 m wide PANEL has a 5 m wide BOARD. Nevertheless, the WALER MK-120 will be 2,375 m long.
The 125 mm difference between the length of the WALER MK-120 and the width of the BOARD will be shared
equally on both sides of the PANEL (i.e., the BOARD will be 6,25 cm out from both sides of the WALER MK-120).
The BOARD must be centred in the PANEL.
=
=