Ulma ENKOFORM VMK - Page 52

ENKOFORM VMK
Construcción
52


ENKOFORM VMK
5.- The arms are inserted in the section of the WALER
MK-120.
6.- The SCREWER will be used to tie up the nuts
electrically.
7.- The WALER-VM20 CLAMP 2T is properly tied up.
General view of the assembly of the WALER-VM20 CLAMP 2T.
The SCREWER KEY URVM20 20 can be used to
tighten the screw of the CLAMP RVM20 2T
electrically.
The screwdriver should have a ½” head.