Ultimaker S5 - Page 21

21
Load material 1
Material 1 will be put on the material guide first before placing it on the spool holder to avoid tangling of the 2 materials
during printing. Select material 1 from the list on the touchscreen, select Start, and follow the steps below.
1. Take the material guide and hold it with the outer part towards you.
2. Place the material spool with material 1 (Tough PLA) on the material guide with the material in a counter-clockwise
direction, and guide the end of the material through the hole in the material guide.
3. Place the material guide with material 1 on it onto the spool holder behind material 2, and select Confirm.
4. Wait until the Ultimaker S5 detects the material and select Confirm.
When using a third-party material, you can select the material type manually.
5. Insert the end of the material into feeder 1 and gently push it until the feeder grips it and the material is visible in
the Bowden tube. Select Confirm to continue.
You can straighten the end of the material so it can enter the feeder easier.
6. Wait for the Ultimaker S5 to heat up print core 1 and to load the material into the print head.
7. Confirm when the new material extrudes consistently from print core 1.
8. Wait a moment for print core 1 to cool down.