Ultimaker S5 User Manual

4
Preface
This is the installation and user manual for your Ultimaker S5. This manual contains chapters about the installation and
use of the 3D printer.
The manual contains important information and instructions on safety, installation and use. Please read all information
and follow the instructions and guidelines in this manual carefully. This ensures that you will obtain great quality prints
and that possible accidents and injuries are prevented. Make sure that everyone who uses the Ultimaker S5 has access
to this manual.
Every effort has been made to make this manual as accurate and complete as possible. The information is believed to
be correct but does not aim to be all inclusive and shall be used only as a guide. Should you discover any errors or
omissions, please bring this to our attention, so that we can make amendments. This will enable us to improve our
documentation and service to you.

Ultimaker S5 Specifications

General

Build Volume	330 x 240 x 300 mm
Layer Resolution	20 - 600 microns
Filament Diameter	2.85 mm
Max Nozzle Temperature	280 °C
Max Build Plate Temperature	140 °C
Print Technology	Fused Filament Fabrication (FFF)
Number of Print Heads	2
Build Plate	Heated glass build plate
Operating Sound	50 dBA
Print Speed	Up to 24 mm³/s
Display	4.7-inch color touchscreen
Operating Temperature	15 - 32 °C
Nozzle Diameter	0.25, 0.4, 0.6, 0.8 mm
Connectivity	Ethernet, Wi-Fi, USB
Supported Materials	PLA, ABS, Nylon, CPE, PVA, TPU 95A, PC, PP
Dimensions	495 x 585 x 780 mm
Feeder Type	Dual-geared
Print Head Movement Speed	300 mm/s
Build Plate Heating Time	Less than 4 minutes
Power Consumption	350 W
Travel Speed	300 mm/s
Operating Humidity	20 - 80% (non-condensing)