Unify OpenScape Desk Phone IP 55G - Page 109

Enhanced phone functions 109
Deflecting a second call
Prerequisite: You are conducting a call and call waiting is allowed  Page 109.
A second call rings.
Select the softkey to confirm.
j Enter the phone number and confirm.
The second call is deflected to the destination specified.
Connecting parties
Confirm with the softkey for the active connection. The other two parties are now
connected to one another. You can now hang up or dial another number for in
-
stance.
or Connecting by hanging up
Prerequisite: Connecting by hanging up is activated (ask your administrator)
and "Switch assignment" must be set to "Yes" (
 Page 110).
] or Replace the handset or, if you are in speakerphone mode, press the loudspeak-
er key. The other two parties are now connected to one another.
Allowing call waiting
z
You can also configure this setting via the WBM interface  Page 247.
Prerequisite: The option was programmed by your administrator.
Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown in the context menu.
Select the softkey to confirm.
Assuming Allow call waiting is activated, you can toggle a configured key to
switch call waiting on/off (
 Page 97).
Deflect
Transfer now
Speaker
If the call waiting (second call) function is deactivated, a caller hears the
busy signal if you are already conducting a call.
Services
User
Configuration
Incoming calls
Handling
Allow call waiting
Yes
Save & Exit