UnionNet SP2100 - Ean-13; B.5 - Ean-13

APPENDIX B - SP2100 2D Imager Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
2D Imager
Only
Programming “ON”
Programming “OFF”
Figure B.0
Instructions: To change the option, first scan the Programming “ON” barcode.
Then scan the Option Code. Finally scan the Programming “OFF” barcode.
27
B.4 - UCC/EAN-8, con’t
5-Digit Addenda Code in Red
Transmit EAN-8
5-Digit Addenda
Don’t Transmit
EAN-8 5-Digit Addenda
EAN-8
Expand to EAN-13
EAN-8
NO Expand to EAN-13
B.5 - EAN-13
Set EAN-13
Factory Defaults
Enable
EAN-13
Disable
EAN-13
Transmit EAN-13
Check Digit
(Single, Right)
Don’t Transmit
EAN-13 Check Digit
(Single, Right)
2-Digit Addenda Code in Red
Transmit EAN-13
2-Digit Addenda
Don’t Transmit
EAN-13 2-Digit Addenda
5-Digit Addenda Code in Red
Transmit EAN-13
5-Digit Addenda
Don’t Transmit
EAN-13 5-Digit Addenda