UnionNet SP2100 - Matrix 2 0 F 5 (Code ID: X); Code 93 (Code ID: L)

APPENDIX C - SP2100 1D LASER Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
1D LASER ONLY
55
C.11 - Matrix 2 0f 5 (Code ID: X)
Programming “OFF” Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Matrix
2 of 5
Programming “ON”
Programming “OFF”
Disable Matrix
2 of 5
Programming “ON”
Enable Check
Digit (USS)
Programming “ON”
Disable Check
Digit (USS)
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1
Programming “OFF” Programming “OFF”
C.12 - Code 93 (Code ID: L)
Programming “ON”
Enable Check Digit
Programming “ON”
Disable Check Digit
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1
Programming “ON”
Programming “OFF”
Disable Code 93
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Code 93