UnionNet SP2100 - UCC; EAN 128 (Code ID: K)

APPENDIX C - SP2100 1D LASER Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
1D LASER ONLY
58
Programming “OFF” Programming “OFF”
Disable Truncate
Leading Zeros
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Truncate
Leading Zeros
C.15 - UCC / EAN 128 (Code ID: K)
Programming “ON”
Programming “OFF”
Disable UCC/EAN 128
Programming “ON”
Enable Check Digit
Programming “ON”
Disable Check Digit
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable UCC/EAN 128
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section CXX
Scan 2 digits from
Section CXX