UnionNet SP2100 - ISBT 128 (Code ID: K); Code 11 (Code ID: V)

APPENDIX C - SP2100 1D LASER Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
1D LASER ONLY
59
Programming “OFF” Programming “OFF”
C.16 - ISBT 128 (Code ID: K)
Programming “ON”
Programming “OFF”
Disable ISBT 128
Programming “ON”
Enable Check Digit
Programming “ON”
Disable Check Digit
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable ISBT 128
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1
Programming “OFF” Programming “OFF”
C.17 - Code 11 (Code ID: V)
Programming “ON”
Programming “OFF”
Disable Code 11
Programming “ON”
Enable Check Digit
Programming “ON”
Disable Check Digit
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Code 11
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1