UnionNet SP2100 - Isbn; Industrial; B.19 - Industrial 25

APPENDIX B - SP2100 2D Imager Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
2D Imager
Only
Programming “ON”
Programming “OFF”
Figure B.0
Instructions: To change the option, first scan the Programming “ON” barcode.
Then scan the Option Code. Finally scan the Programming “OFF” barcode.
36
Code 11 - Double Check
Digits, MOD 11/ MOD 11
Code 11 Single
Check Digit, MOD 11
Code 11 - Double Check
Digits, MOD 11/ MOD 9
B.17 - Code 11, con’t
Code11SingleCheckDigitMOD11Len<=10)
DoubleCheckDigitsMOD11/MOD11Len>10)
Code11SingleCheckDigitMOD11Len<=10)
DoubleCheckDigitsMOD11/MOD9Len>10)
B.18 - ISBN
Enable
ISBN
Disable
ISBN
Set ISBN
Factory Defaults
ISBN - Transmit
10 Digits
ISBN - Transmit
13 Digits
B.19 - Industrial 25
Enable
Industrial 25
Disable
Industrial 25
Set Industrial 25
Factory Defaults
● Transmit Check Digit - The last digit is a check digit. Perform the mathematical check using the last digit as validation. Transmit the
check digit as part of the string to the host.
● Check Digit Don’t Transmit - The last digit is a check digit. Perform the mathematical check using the last digit as validation, but
don't transmit the check digit to the host.
Min and Max String Lengths - To limit the length of the barcode string as a form of validation, you can set a minimum and maximum
string length. These lengths include check and stop/start digits if applicabl to the symbology. To set the string length:
1. Scan the Programming “ON” barcode.
2. Scan the Set Min Length barcode, then scan the digit code(s) from Section B.29 of this Appendix (B) for the number representing
the minimum length.