UnionNet SP2100 - GS1 Databar Limited (Code ID: R); GS1 Databar Expanded (Code ID: R)

APPENDIX C - SP2100 1D LASER Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
1D LASER ONLY
61
C.20 - GS1 Databar Limited (Code ID: R)
Programming “OFF” Programming “OFF”
Programming “ON”
Programming “OFF”
Programming “ON”
Enable Convert to
UCC / EAN-128
Programming “ON”
Disable All
Conversion
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable GS1 Databar
Limited
Disable GS1 Databar
Limited
Enable Convert to
UPC-A/ EAN-113
Programming “OFF”
C.21 - GS1 Databar Expanded (Code ID: R)
Programming “ON”
Programming “OFF”
Programming “ON”
Enable Convert to
UCC / EAN-128
Programming “ON”
Programming “OFF”
Enable GS1 Databar
Expanded
Disable GS1 Databar
Expanded
Disable All
Conversion
Programming “ON”
Programming “OFF”
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1