UnionNet SP2100 - Code 128 (Code ID: K)

APPENDIX C - SP2100 1D LASER Setup Barccodes, con’t
BarcodeGuy.com® - UnionNet SP2100 User’s Guide
1D LASER ONLY
57
Programming “OFF” Programming “OFF”
Disable Truncate
Leading Zeros
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Truncate
All Leading Zeros
C.14 - Code 128 (Code ID: K)
Programming “ON”
Programming “OFF”
Disable Code 128
Programming “ON”
Enable Check Digit
Programming “ON”
Disable Check Digit
Programming “ON”
Programming “OFF”
Disable Transmit
Check Digit
Enable Transmit
Check Digit
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Enable Code 128
Enable Truncate
First Leading Zero
Programming “ON”
Programming “OFF”
Set Max Length
(00-99) Default=99
Programming “ON”
Programming “OFF”
Programming “ON”
Programming “OFF”
Set Min Length
(00-99) Default=01
Scan 2 digits from
Section C.A1
Scan 2 digits from
Section C.A1