Unitech MS282 - Page 102

-85- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
• Length Within Range - Decode D 2 of 5 symbols with a specific length
range. Select lengths using the bar codes in
Appendix B, Numeric Bar Codes. For example,
to decode D 2 of 5 symbols containing between 4
and 12 characters, scan D 2 of 5 - Length Within
Range, and then scan 0, 4, 1, 2. To correct an
error or change the selection, scan Cancel.
•Any Length - Decode D 2 of 5 symbols containing any number of
characters within the engine’s capability.
Note: Due to the construction of the D 2 of 5 symbology, it is possible for a scan line
covering only a portion of the code to transmit as a complete scan, yielding less data
than is encoded in the bar code. To prevent this, select specific lengths (D 2 of 5 -
One Discrete Length, Two Discrete Lengths) for D 2 of 5 applications.
D 2 of 5 - One Discrete Length*
(Default: 12)
D 2 of 5 - Two Discrete Lengths
D 2 of 5 - Length Within Range
D 2 of 5 - Any Length