Unitech MS282 - Check ISBT Table; ISBT Concatenation Redundancy

-56- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.3.30 Check ISBT Table
The ISBT specification includes a table that lists several types of ISBT bar
codes that are commonly used in pairs. If you set ISBT Concatenation to
Enable, enable Check ISBT Table to concatenate only those pairs found
in this table. Other types of ISBT codes are not concatenated.
3.3.31 ISBT Concatenation Redundancy
If you set ISBT Concatenation to Autodiscriminate (the default), use this
parameter to set the number of times the engine must decode an ISBT
symbol before determining that there is no additional symbol.Scan the
following bar code, and then scan bar codes in Appendix B, Numeric Bar
Codes to set a value between 2 and 20. Enter a leading zero for single
digit numbers. To correct an error or change a selection, scan Cancel.
The default is 10.
Enable Check ISBT Table*
Disable Check ISBT Table
ISBT Concatenation Redundancy