Unitech MS282 - Set Lengths for Interleaved 2 of 5

-77- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.7.1 Set Lengths for Interleaved 2 of 5
The length of a code refers to the number of characters (i.e., human
readable characters), including check digit(s) the code contains. Set
lengths for I 2 of 5 to any length, one or two discrete lengths, or lengths
within a specific range. The default is One Discrete Length: 14.
Note: When setting lengths, enter a leading zero for single digit numbers.
Scan one of the following bar codes to select a length option:
• One Discrete Length - Decode only I 2 of 5 symbols containing a selected
length. Select the length using the bar codes in
Appendix B, Numeric Bar Codes. For example, to
decode only I 2 of 5 symbols with 14 characters,
scan I 2 of 5 - One Discrete Length, and then scan
1, 4. To correct an error or change the selection,
scan Cancel.
• Two Discrete Lengths - Decode only I 2 of 5 symbols containing either of
two lengths. Select lengths using the bar codes
in Appendix B, Numeric Bar Codes. For example,
to decode only I 2 of 5 symbols containing either
2 or 14 characters, scan I 2 of 5 - Two Discrete
Lengths, and then scan 0, 2, 1, 4. To correct an
error or change the selection, scan Cancel.
• Length Within Range - Decode I 2 of 5 symbols with a specific length
range. Select lengths using the bar codes in
Appendix B, Numeric Bar Codes. For example,
to decode I 2 of 5 symbols containing between 4
and 12 characters, scan I 2 of 5 - Length Within
Range, and then scan 0, 4, 1, 2. To correct an
error or change the selection, scan Cancel.
•Any Length - Decode I 2 of 5 symbols containing any number of characters
within the engine’s capability