-84- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.8 Discrete 2 of 5 (DTF)
Scan one of the following bar codes to enable or disable Discrete 2 of 5.
3.8.1 Set Lengths for Discrete 2 of 5
The length of a code refers to the number of characters (i.e., human
readable characters), including check digit(s) the code contains. Set
lengths for D 2 of 5 to any length, one or two discrete lengths, or lengths
within a specific range. The default is One Discrete Length: 12.
Note: When setting lengths, enter a leading zero for single digit numbers.
Scan one of the following bar codes to select a length option:
• One Discrete Length - Decode only D 2 of 5 symbols containing a
selected length. Select the length using the bar
codes in Appendix B, Numeric Bar Codes. For
example, to decode only D 2 of 5 symbols with 14
characters, scan D 2 of 5 - One Discrete Length,
and then scan 1, 4. To correct an error or change
the selection, scan Cancel.
• Two Discrete Lengths - Decode only D 2 of 5 symbols containing either of
two lengths. Select lengths using the bar codes
in Appendix B, Numeric Bar Codes. For example,
to decode only D 2 of 5 symbols containing either
2 or 14 characters, scan D 2 of 5 - Two Discrete
Lengths, and then scan 0, 2, 1, 4. To correct an
error or change the selection, scan Cancel.
Enable Discrete 2 of 5
Disable Discrete 2 of 5*
To Next Page
Loading...
