Unitech MS282 - Suppress Power up Beeps; LED on Good Decode; Direct Decode Indicator

-18- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.3.5 Suppress Power Up Beeps
Scan one of the following bar codes to select whether or not to suppress
the engine’s power-up beeps.
Do Not Suppress Power Up Beeps* Suppress Power Up Beeps
2.3.6 LED on Good Decode
Scan one of the following bar codes to select whether or not the LED blinks
on a good decode.
Enable LED on Good Decode* Disable LED on Good Decode
2.3.7 Direct Decode Indicator
This parameter is only supported in Auto Aim and Standard (Level) Trigger
Mode. Scan one of the following bar codes to select optional blinking of the
illumination on a successful decode.
•*Disable Direct Decode Indicator - Illumination does not blink on a
successful decode.
•1 Blink - Illumination blinks once upon a successful decode.
•2 Blinks - Illumination blinks twice upon a successful decode.
Disable Direct Decode Indicator* 1 Blink
2 Blinks