Unitech MS282 - Decode Session Timeout

-24- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.9 Decode Session Timeout
This parameter sets the maximum time decode processing continues
during a scan attempt. It is programmable in 0.1 second increments from
0.5 to 9.9 seconds. The default timeout is 9.9 seconds. To set a Decode
Session Timeout, scan the following bar code, and then scan two bar
codes from Appendix B, Numeric Bar Codes that correspond to the
desired on time. Enter a leading zero for single digit numbers. For
example, to set a Decode Session Timeout of 0.5 seconds, scan this bar
code, and then scan the 0 and 5 bar codes. To correct an error or change
the selection, scan Cancel.
Decode Session Timeout