Unitech MS282 - 2.3 Beep & Indicator Setting

-16- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.3 Beep & Indicator Setting
2.3.1 Beep After Good Decode
Scan one of the following bar codes to select whether or not the engine
beeps after a good decode. If you select Disable Beep After Good Decode,
the beeper still operates during parameter menu scanning and to indicate
error conditions.
Enable Beep After Good Decode* Disable Beep After Good Decode
2.3.2 Beeper volume
Scan one of the following bar codes to select a beeper volume.
Low Volume Medium Volume
High Volume*