Unitech MS282 - Transmit “No Read” Message

-28- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.12 Transmit “No Read” Message
Scan one of the following bar codes to set an option for transmitting the
No Read (NR) characters:
•Enable No Read - This transmits the characters NR when a successful
decode does not occur before trigger release or the
Decode Session Timeout expires.
•Disable No Read - This sends nothing to the host if a symbol does not
decode.
NOTE: If you enable Transmit No Read, and also enable Symbol Code ID Character or
AIM Code ID Character for Transmit Code ID Character, the engine appends the
code ID for Code 39 to the NR message.
This does not apply in presentation mode.
Enable No Read
Disable No Read*