Unitech MS282 - Scan Data Transmission Format

-30- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.14 Scan Data Transmission Format
To change the scan data format, scan one of the following bar codes
corresponding to the desired format.
NOTE : If using this parameter do not use ADF rules to set the prefix/suffix.
Data As Is*
<PREFIX> <DATA> <SUFFIX 1>
<DATA> <SUFFIX 1>
<PREFIX> <DATA> <SUFFIX 2>
<DATA> <SUFFIX 2>
<PREFIX> <DATA> <SUFFIX 1> <SUFFIX 2>
<DATA> <SUFFIX 1> <SUFFIX 2>
<PREFIX> <DATA >