Unitech MS282 - Transmit UPC-E1 Check Digit

-44- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.3.15 Transmit UPC-E1 Check Digit
The check digit is the last character of the symbol used to verify the
integrity of the data. Scan one of the following bar codes to transmit the bar
code data with or without the UPC-E1 check digit. It is always verified to
guarantee the integrity of the data.
Transmit UPC-E1 Check Digit *
Do Not Transmit UPC-E1 Check Digit