Unitech MS282 - Set Bar Codes Enable;Disable; Parameter Barcode Scanning

- 128 - © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
3.19 Set Bar Codes Enable/Disable
Scan below bar code to enable / disable bar code setting.
Enable*
Disable
3.20 Parameter barcode scanning
Scan one of the following bar codes to select whether to enable or disable the
decoding of parameter bar codes, including the Set Defaults bar codes.
Enable Parameter Bar Code
Scanning*
Disable Parameter Bar
Code Scanning