-29- © 2018 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS282 User’s Manual
2.13 Prefix/Suffix Values
You can append a prefix and/or one or two suffixes to scan data for use in
data editing. To set a value for a prefix or suffix, scan one of the following
bar codes, and then scan four bar codes from Appendix B, Numeric Bar
Codes that correspond to that value. See Appendix A, ASCII Character
Sets for the four-digit codes. When using host commands to set the prefix
or suffix, set the key category parameter to 1, and then set the 3-digit
decimal value. See Appendix A, ASCII Character Sets for the four-digit
codes.The default prefix and suffix value is 7013 <CR><LF> (Enter key).
To correct an error or change a selection, scan Cancel.
NOTE: To use Prefix/Suffix values, first set the Scan Data Transmission Format.
Scan Prefix
Scan Suffix 1
Scan Suffix 2
Data Format Cancel
To Next Page
Loading...
